Copyright WWW.DBBP.COM | updated 4 September-2007



Knucklehead project started May 2007,

Thanks to Knukkel at Oldskoolchoppers.nl
I was able to borrow a knucklehead engine for a while!
I will take it apart, measure and model all the parts in CAD,
and then put it back together again...

 
 
 

Started on the right crankcase.

Used the Bridgeport to measure the
coordinates of all the holes. Wrote
them all down and input them into the computer
as a starting point for the CAD model.

It's not much yet, but it's a start!

Time spent this week 4 hours.

Total time spent sofar 90 hours.

 


Previous