|
Project started
December 2020,
See the CAD version here
| In Februari I picked up the bike at @fredflitzefuss place, the
dragbar was temporary so I could finish the real handlebars and
so it would fit in the van. |
| After arriving home I modified the PCP handlebar clamp so the
brakeline will go through the left riser and into the left rear
leg of the springer. Then I took the bike outside to see how it
looked and to get some decent pics |
| I had planned to re-use the stock dash but now I have changed
my mind and will make a one-off. Also I need to remove the stock
coilmounts from the seatpost as I will be hiding the coil between
the tanks, and I will be modifying the front seatmount. If only
I had more time to work on my own bike..... |
|
